Placa Trigorilla Anycubic

Volver al menú de impresión 3D

Manufacturer Description

TriGorilla is a main board developed by Anycubic R&D team that integrated with the mighty function of the Mega 2560+ramps 1.4 on respect of both software and hardware and has more premium features; the streamlined interfaces avoid the unnecessary troubles effectively and power than Ramps 1.4 + Mega2560, it is a feature rich all-in-one electronics solution for Reprap Mendel Prusa and other CNC devices

TriGorilla adopts DC-DC step-down scheme design and Recoverable fuse for short-circuit protection, improving the MEGA2560 board serious heating problem. Allowing any power supply from 10V-30V

Specifications:

Main Control Chip: ATMEGA256016AU
Input Power: 10V ~ 30V
Standby Current: 35mA±5mA
Stepper Motor Drivers: 5 channel Max
Hot bed Output Control: 1 channel
Heated output control: 2 channel
Under-current output control: 3 channel
Dimensions: 125mm x 82mm

Package List:

1* TriGorilla main board

Product Features

Integrated with the mighty function of the Mega 2560+ramps 1.4 kit, Great reduce the wiring problem, more convenient connection, and more stable. Widely used in 3D printers like Kossel, Prusa i3, corexy, etc Firmware can use the same configuration as ramps 1.4, the marlin firmware which runs in Mega2560+ramps 1.4 kits can run in TriGorilla board directly Adopt ATmega2560 as the main control chip, coupled with the high performance USB serial converter CP2102. Support LCD2004 and LCD12864 without using adapter Support up to 5 motor drivers, support A4988/ DRV8825 /TMC2100 driver: Motor drive circuit doesn't integration on the circuit board, you can change any stepper motor driver you need, easier to operate. TriGorilla had reserved SERVO, UART, IIC expansion, so you can control touch screen smart controller, control wireless module and the detection of break, etc

Trigorilla. Que va en cada cosa

Trigorilla. Información de los pines

Aspecto con el cableado conectado. No está la cama caliente conectada, ni para el autonivelado.

Diferentes hardware conectados a la mainboard

Diferencias en ruido que ofrecen El Trinamic2100 vs los A4988 al momento de imprimir

Si necesitas hacer una prueba con 12VCC. Por ejemplo un ventilador. Conecte el cable rojo en 12 V y el negro a GND.

Jumper DC/USB de la Trigorilla 

Modelo stl de la placa. URL: https://www.thingiverse.com/thing:2515499

Volver al menú de impresión 3D